Cutting the weight off a non-comp diff mount
01-01-12, 05:05 PM
#1
Slung all my rods
Thread Starter
iTrader: (2)
Join Date: Dec 2011
Location: Arab, AL
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
Cutting the weight off a non-comp diff mount
Anyone done this? Would it effect anything? I am doing a pinion snubber/diff mount install and cutting the weight off the front would give me more room to wrench.
01-02-12, 02:45 PM
#3
Slung all my rods
Thread Starter
iTrader: (2)
Join Date: Dec 2011
Location: Arab, AL
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
Good to know, I was specfically refering to it being kind of in the way of the front lower bolt/nut for swinging a wrench without dropping the entire subframe.
Thread
Thread Starter
Forum
Replies
Last Post