cusco camber plate install
04-07-03, 03:18 PM
#1
Senior Member
Thread Starter
Join Date: Mar 2002
Location: Springfield, MO
Posts: 333
Likes: 0
Received 0 Likes
on
0 Posts
cusco camber plate install
Has anyone installed these? they are going on my 86. There are 3 peices to it. I know where the plate and the threaded nut part go but there is another metal piece that i dont konw where it goes.
its the bigger metal pieces on the top outside.
are there any instructions online or has anone installed these?
its the bigger metal pieces on the top outside.
are there any instructions online or has anone installed these?
04-07-03, 09:22 PM
#2
No longer cares
Join Date: Apr 2002
Location: just a bit north of your business
Posts: 1,345
Likes: 0
Received 0 Likes
on
0 Posts
The center bearing rides on that other piece. The spring has a perch at the top of it which has a pivot bearing at the center. You need to place that spacer on the bottom side of the camber plate to allow the strut to rotate. (so you can turn)
It's also possible that you would eliminate that bearing with the kit because they use bearings at the top of the strut. If you have lowering springs you will not need a compressor to take the strut top off and you can take pics of what you find and I'll help you from there. I forget exactly how mine went together when I swapped out my old ****.
It's also possible that you would eliminate that bearing with the kit because they use bearings at the top of the strut. If you have lowering springs you will not need a compressor to take the strut top off and you can take pics of what you find and I'll help you from there. I forget exactly how mine went together when I swapped out my old ****.
Thread
Thread Starter
Forum
Replies
Last Post
