Correct front cover gasket/oring?
#1
Full Member
Thread Starter
Join Date: Feb 2007
Location: Southern CA
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
Correct front cover gasket/oring?
Hi, I have an NA s4 and I can't decide if this is the correct gasket. I purchased rebuild kit A from Atkins and not sure if I should use the provided front cover gasket? Its not machined for the Teflon o ring, but it seems like theres a large hole on this gasket, see picture. Can I just trim off the portion of the gasket over the o ring, and keep the outer perimeter for sealing? want as much compression as possible over this o ring. Suggestion please.
Also, having a hard time choosing the correct o rings. This kit came with two O rings that i'm not sure if it's for the front cover. There's another O ring that is slightly smaller in diameter and thicker. Should I use that one for more compression/better seal? or does the one I have in the picture look correct.
Also, having a hard time choosing the correct o rings. This kit came with two O rings that i'm not sure if it's for the front cover. There's another O ring that is slightly smaller in diameter and thicker. Should I use that one for more compression/better seal? or does the one I have in the picture look correct.
Thread
Thread Starter
Forum
Replies
Last Post
David Hayes
3rd Generation Specific (1993-2002)
13
09-05-22 12:45 PM