Compression At Zero
Thread Starter
Junior Member
Joined: Oct 2004
Posts: 7
Likes: 0
From: upstate new york
Compression At Zero
Fellas My S5 T2 Will Not Turn Over. Rear Rotor Read 120psi Compression T And L Plugs Front Rotor At Zero Nothing Notha S5 J-spec With All Emissions Removed In S4 T2 Motor Hasan't Been Started In A While Possiblestuck Rotor? Added Trany Oil Tried Unflooding Notha How About Clutch Starting It ? There Is Gas Spark Something Got To Give Stuck Or Blown?
not even one face has compression? you must have blown two apexes... either that or 3 side seals. wait, do you have both spark plugs out on the front rotor? that would make it hard to make compression...
Joined: Oct 2003
Posts: 11,576
Likes: 27
From: Morristown, TN (east of Knoxville)
Could be badly stuck seals or a blown engine. either way you'll likely have to pull it apart for a refresh/rebuild. No use fighting the inevitable.
Thread
Thread Starter
Forum
Replies
Last Post
turbodreamz22
General Rotary Tech Support
28
Nov 10, 2023 11:08 AM