Clutch Replacement Issues
#1
Clutch Replacement Issues
I removed the clutch on a 88 convertible. I noticed that the bolts attaching the pressure plate to the flywheel were not the same size. Two bolts were 14mm and the other four were 13mm and slightly shorter. Also, there were spacers on only three of the bolts.
Are these bolts supposed to be different? and how many spacers, if any are there supposed to be??
Also, approximately how long are those bolts supposed to be??
Thanks for any advise
Iván
Are these bolts supposed to be different? and how many spacers, if any are there supposed to be??
Also, approximately how long are those bolts supposed to be??
Thanks for any advise
Iván
#2
Open up! Search Warrant!
Join Date: May 2002
Location: Kicking down doors in a neighborhood near you
Posts: 3,838
Likes: 0
Received 2 Likes
on
2 Posts
they should be the same. Its a rotating object and should be balanced. Go to napa and get 4 bolts and washers that are the same. Take an old bolt so they can measure the thread pitch and you won't have to make two trips.
Thread
Thread Starter
Forum
Replies
Last Post