well after almost 5 months of no running i finally got a new motor in her plus mods and after screwing with the fuel system some we got her started and to idle. I'm thinking woo hoo after i shut her off checked everything in the engine bay and was about to take her for a test drive put her in gear and went to start it and the car lurched foward. Well the slave unit wasn't completely bled, so i did that tried again same thing. Now i was looking the the throwout bearing fork and noticed there is play both foward and back and side to side is that ok? and what else could it be I have a SR Motorsports 9.5lb Flywheel with a ACT 6 puck plus a Stainless steal line. Any suggestions would be helpful.

 

bump

 

did you forget to put the throwout bearing in?

 

or the pivot point for the arm broke.