Clogged Oil injector passage on rotor housing!!!
03-16-04, 05:30 PM
#1
Daily Domestic Killer
Thread Starter
Join Date: Mar 2001
Location: San Antonio, Tx, USA
Posts: 2,425
Likes: 0
Received 0 Likes
on
0 Posts
Clogged Oil injector passage on rotor housing!!!
I need some help quick, I have tried to removed the little brass colored oil passage on the rotor housing with a big *** flat head with no sucess, I've been spaying it and soaking it in brake parts cleaner with no luck.
the reason I believe the oil injector passage is clogged is because I can see oil pooling around that injector and when I removed the injector the hole was filled with oil, unlike the others when they where removed..
I'm so close to jsut ripping the damn omp off again, but maybe was thing about just using the 2 injectors on the LIM and blocking the other 2 off, but not sure if that would work either...
the reason I believe the oil injector passage is clogged is because I can see oil pooling around that injector and when I removed the injector the hole was filled with oil, unlike the others when they where removed..
I'm so close to jsut ripping the damn omp off again, but maybe was thing about just using the 2 injectors on the LIM and blocking the other 2 off, but not sure if that would work either...
03-16-04, 06:15 PM
#3
Mountain Rotary Mod
Join Date: Nov 2003
Location: Freaking Poland!!
Posts: 2,411
Likes: 0
Received 0 Likes
on
0 Posts
Pull the OMP (unless it's S5 then you have to lave it attached) and just premix. My car runs better with premix and you don't have to worry about oil injectors.
Thread
Thread Starter
Forum
Replies
Last Post
