what are the possible causes for an engine to have no compression on one (in this case its the front) rotor? im looking for least costly repair first. hahaha

 

Multiple blown apex seals. At best a rebuild is needed, then you have to worry about what the seals did to the housings when they flew around in there.

Sure theres a slight possiblity that theyre just stuck and can be unstuck with the water or another trick but I highly doubt that'll cause absolute zero compression.

 

i had this same thing. my rotor housing and rotor were unuseable

 

could have a blown coolant seal

 

stuck or broken apex seals, a blown coolant seal would not cause no compression.

 

damn. yeah the needle on my gaueg barely moved when spinning the engine. the rear was 90-90-90 but the front hardly bumped at all.