Car bogs at low rpm
#1
Full Member
Thread Starter
Join Date: Oct 2005
Location: Federal Way
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
Car bogs at low rpm
S4 Turbo II.
When I drive the car under 3000 rpms at about 1/4 to 1/2 throttle it bogs down and wont go and i have to feather the throttle sometimes. It happens especially on hills. I changed my fuel injectors, and adjusted my Tps but none of those fixed it. Also revving it at low rpms it goes up slow, feels like no throttle response. After 3000rpm it seems to go fine. Also my Tps at WOT is at 6.7ohms.
When I drive the car under 3000 rpms at about 1/4 to 1/2 throttle it bogs down and wont go and i have to feather the throttle sometimes. It happens especially on hills. I changed my fuel injectors, and adjusted my Tps but none of those fixed it. Also revving it at low rpms it goes up slow, feels like no throttle response. After 3000rpm it seems to go fine. Also my Tps at WOT is at 6.7ohms.
Last edited by importedboi; 04-25-06 at 06:53 PM.
Trending Topics
#9
"On the grind"
iTrader: (15)
Yes some one has to have a solution sounds like lots of fellow fc owners are having the same issue....
My issue just started happening after i pulled engine to paint my engine bay. Did the rats nest removal, ran absolutely perfect b4 i did this..
Checked and i hav no vacume leaks, could this be a grounding issue? Tps is in working order per fsm.
Bogs down at full throttle, and hessitates (bucks) wen starting out from a dead stop, have to ease the pedal to get going and stop the bucking..
non turbo s4 rats nest removed
115 on both rotors
9lbs alluminum fly
stage 2 spec clutch and pressure plate.
Full T2 drivetrain..
My issue just started happening after i pulled engine to paint my engine bay. Did the rats nest removal, ran absolutely perfect b4 i did this..
Checked and i hav no vacume leaks, could this be a grounding issue? Tps is in working order per fsm.
Bogs down at full throttle, and hessitates (bucks) wen starting out from a dead stop, have to ease the pedal to get going and stop the bucking..
non turbo s4 rats nest removed
115 on both rotors
9lbs alluminum fly
stage 2 spec clutch and pressure plate.
Full T2 drivetrain..
#10
Rotary Enthusiast
if you pulled the engine then your gas probably went bad during the time it took you to do your engine work. my car bogged at low rpms when i had bad gas i put sea foam in it and used higher octane fuel and it ran great.
Thread
Thread Starter
Forum
Replies
Last Post