can someone plz tell me where the heat guage sendor is???
#1
Rotary Enthusiast
Thread Starter
Join Date: Feb 2008
Location: tennessee
Posts: 900
Likes: 0
Received 0 Likes
on
0 Posts
can someone plz tell me where the heat guage sendor is???
i cant find it and all i need is took hook up my heat guage also the wire that connects to it would be awsome too
#3
Road Rotary Aviator
Join Date: Apr 2004
Location: Oregon
Posts: 499
Likes: 0
Received 0 Likes
on
0 Posts
you can take your dash out and pull the wire out of the the main plug on it if you'd like but I suggest running a new wire to save time. Both senders for the gauges are underneath the oil filter pedestal.
#4
Rotary Enthusiast
Thread Starter
Join Date: Feb 2008
Location: tennessee
Posts: 900
Likes: 0
Received 0 Likes
on
0 Posts
i have looked and i have 2 sensers 1 is right beside to the left of the oil pressure unit and the only other 1 is above it on the uper or middle intake and it ahs 2 prongs. and the sensor beside the oil pressure unit seems to work my oil pressure guage so the only other 1 is the 2 prong one on the intake and it dosent work for my temp guage.
#6
putting it down daily
If you are putting in an aftermarket gauge, don't even think of using the stock sensor location-it won't fit. Drill & tap your water pump housing in line with the flow of coolant (it becomes apparent where you need to drill once you have the pump off). If you are using the stock one, nvm
#7
Rotary Enthusiast
Thread Starter
Join Date: Feb 2008
Location: tennessee
Posts: 900
Likes: 0
Received 0 Likes
on
0 Posts
if the temp guage sender is right next to the oil psi unit then why does my oil psi guage work when i connect it to this sender because thats what iv done
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM