Brakes:ABS to standard swap questions
#1
Information Regurgitator
Thread Starter
Brakes:ABS to standard swap questions
What is rqeqired to change abs brakes to standard non-abs brakes.Do I just have to change the master cylinder,proportioning valve and metal lines.The reason I am doing this is because I have an 89 TII with a blown engine I had originally purchased as a parts car but now am going to turn it into a project and try to get it back on the road.The previous owner started parting it out some before I got it and had sold the ABS controller that all the brake lines go into.I have an 89 gxl parts car that I can get the master cylinder and other standard brake parts from so I just need to know if there are any other parts other than what I previously stated I have to change.Thanks
#2
you are correct ....all you need to do is pull out all your metal lines and master cylinder then swap in the one out of your 89 gxl...then you have to go throught the usual bleeding procedure...
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM