Hi, I'm currently doing my powersteering line on my RHD S5 Turbo 2. I've put some -6AN adapter fitting on the rack itself but I still have to plug the "balanced" hole on the rack. I've try M12x1.25 plug it only goes for about 1-2 thread than stop, I don't want to forced it. Am I using the right plug or not?

Thank

 

Did you ever figure out what sizes you needed? I am in the same situation. Thanks please let me know

 

this is what I used. Threaded in just fine
uxcell Stainless Steel Inner Hex Head M12x1.25 Pipe Fitting Plug with Seal Ring for Terminate Pipe Ends https://a.co/d/7S7QAC0

 

Good to know! Thank you! Also do you know the thread pitch for the feed and return? Also why are you plugging the balance?

 

M16x1.5 for both return and high pressure ports on the RHD racks. LHD rack uses a M12x1.25 for the high pressure and M16x1.5 for the return line port.

 

thank you so much thats what i need to know!

 

do you also know the thread pitch for the 2 lines that are on the gear housing?

 

What's the reason for blocking the balance? I've been trying to find a m12x1.25 bump tube flare fitting but no luck. any pictures of a rhd completed power steering set up? Also what is everyone doing for power steering coolers ? any help would be appreciated !