Well im seeing conflicting pictures in my manual. I have what i was told a s5 t2 tranny without a bellhousing. Its clearly a t2 just dont know what series. I also have what im told to be a s5 t2 bellhousing. My problem is my bellhousing has 10 bolt holes that hold it on and the tranny only has 8???? Does anyone know what ones have 10 holes and which ones have 8? Thanks

 

from the FSM..the s5 t2 bellhousing is held on with 10 bolts.


pg j2-38

http://www.teamfc3s.org/main/factory...sion_Turbo.pdf

 

Yea i saw that one, but if you look at 21 and 28 it only shows 8.

 

neither of those pages show the bellhousing. i think you might be looking at the other end that holds the shifter casing on.

 

No but they both show the front of the tranny where the bellhousing bolts, and there are only 8.

 

 

You know for sure that pic is a s5? Whats around the bellhousing?

 

S4 pics:
http://www.16paws.com/rx7/index.html

https://www.rx7club.com/2nd-generation-specific-1986-1992-17/scattershield-install-pictures-tii-673402/

 

Well i definitly have a s4 tranny and s5 bellhousing. Do you guys think that not using those two extra bolts would cause a leak? I wouldnt think so just from where there at. I could just use what i have and then get a s5 t2 tranny mount and it would be good, im pretty sure. Can anyone confirm this? I need my car going by this weekend and this would be a big setback. Thanks for the help guys.