auto to manual
04-23-10, 05:38 PM
#1
Senior Member
Thread Starter
auto to manual
i was wondering if there is a detailed writeup on converting for an s4 na
the only one i found was for an s5 and that one was too general
and also i was wondering also wheteher i need the sensor in the back of the intake plenum
the one that goes under the BAC as it broke on me
the only one i found was for an s5 and that one was too general
and also i was wondering also wheteher i need the sensor in the back of the intake plenum
the one that goes under the BAC as it broke on me
04-24-10, 10:32 AM
#2
Full Member
Join Date: Jan 2002
Location: Tampa Bay
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
04-24-10, 06:09 PM
#3
Ongoing Project
Join Date: Jun 2009
Location: Central Mass
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Personally, I think your better off time-wise and financially just buying one already manual transmission. Unless you have already done this before, you will only run into problems.
04-24-10, 06:23 PM
#4
whats a Turbo V?
its not that hard i've done 3.
S5 and S4 trans swap is the same.
might waint to consider gettting an turbo 2 driveline so if you T2 swap later your drive lines already set.
S5 and S4 trans swap is the same.
might waint to consider gettting an turbo 2 driveline so if you T2 swap later your drive lines already set.
04-24-10, 09:45 PM
#6
As rereme said... I found that the hardest part was fabricating a bracket to mount the manual tranny on to the auto frame. i would highly subject to buy a bracket (Like rereme is selling) and cut down time,money and hassle of fabricating your own..