I want to get a MOMO Combat Shift ****, wanted to know if anybody had pics of it in their FC's. I have a friend that has one in his FD, and I love the feel of it, Just never seen one in an FC. Thanks

-marshall

 

I have one but I don't have any pictures right now. I might be able to get some shots later today. If I remember correctly, for a s5 you will need to cut the length of the shifter by a little more than an inch if you want the momo **** to be in the same place as the original. You have a series 4 so you might need to cut a little bit more. Mine is the same height as a stock s5 shifter but i have maybe a 1/4" space from the bottom of the **** to the shift boot.

 

You don't need to cut the shifter, you cut the end off the little rubber cap that comes with ****, this lets you set the **** farther down on the shifter before you tighten the set-screws. I've put a few of these in, my buddy has the one above in his 91 vert. Looks great.

Same buddy also sells MOMO online at www.obbnmotorworks.com, you WILL NOT find cheaper MOMO stuff on the web (sorry for the shill, it seemed like the right place for it!).....

 

Ok, Xentrix pics would be awesome! Thanks

GatorRX that link didn't work to that site.

Anymore guys have this shift ****?? Please let me see pics.

thanks,
marshall

 

that's because you didn't take out the , in the link...

http://www.obbnmotorworks.com

try that...

 

Ah, my bad. Thanks

 

or if anybody has a used one, i will buy it from them.

But yeah, i'd really like to see some pics of it installed on an FC. thanks

-marshall

 

Mine moved around too much without the rubber piece and it was too tall.

dunno what's up with that, but I had to cut mine to make it the same height as a s5 shifter.

 

Ok, did you get a pic of it yet? heh sorry i just really want to know how it looks in an FC

 

I too cut the top of my Shifter (s5) one to accomadate my Momo Tomahawk. By cutting the boot of the shifter, as GatorRX, suggests, doesn't allow suitable height, IMO. I cut off almost an Inche of the shifter. Not only It Is aggresive looking, It Is purely functionable w/o the adverse effects you'd expect with doing such a task.

 

TTT

 

I have a picture, oh wait I put my stock shifter back on Thanks for trading back with me

 

hahaha, yeah thanks, I don't really care though matt i'm getting the momo combat! Oh yeah, and you must be in school, maybe you should pay attention and not be on the Great and Holy RX-7 Forum.


TTT pics?

 

The camera I used didn't have flash and the parking garage isn't bright enough.







edit: changed the pics to dialup friendly

 

thatll look badass on your car man you puttin it on the AE or the new rx? or both

 

Sorry, fat fingered the URL, accidentally type a ',' at the end

www.obbnmotorworks.com

You still use the rubber piece, but you cut the closed end off, so its like a tube. Slide that on, then slide the **** on, the rubber piece will sit much lower, and the **** sits on that. If you want it super short, you might want to cut the shifter. I don't like that, though, I think the shifter isn't very precise after you do that...

 

thanks for the pics