Another timing question
#76
Theoretical Tinkerer
iTrader: (41)
Ok cars runs great!(besides the vacuum caps popping off)
I hit a wall when boost hits 8.6 psi, I'm assuming is because the factory ecu.
Will the ecu cut off at 8.6 psi with the fuel pump wired to the battery?
Thanks to everybody for helping me out.
I'll never buy another reman AFM.
I hit a wall when boost hits 8.6 psi, I'm assuming is because the factory ecu.
Will the ecu cut off at 8.6 psi with the fuel pump wired to the battery?
Thanks to everybody for helping me out.
I'll never buy another reman AFM.
Now can you get your idle below 1k, so you can finally set your timing?
#77
No Sleep
Thread Starter
Ok. Then I won't buy the FCD until I install the wideband.
Yes! It was a short lived miracle.
I got it down to 900 rpm then timed it and it dropped to 700 rpm.
It was advanced by about 20 degrees.
Idk why but now I can't get it lower than 1100 but at this moment I'm already satisfied.
Plus I have confidence that the timing is dead on.
Yes! It was a short lived miracle.
I got it down to 900 rpm then timed it and it dropped to 700 rpm.
It was advanced by about 20 degrees.
Idk why but now I can't get it lower than 1100 but at this moment I'm already satisfied.
Plus I have confidence that the timing is dead on.
#80
No Sleep
Thread Starter
That's exactly why I'm not gonna buy the FCD until I've installed the wideband.
#81
No Sleep
Thread Starter
Ok fixed the vacuum cap problem and car idles at 700 strong.
Timing is dead on!
But now since this is a 6 port turbo and I'm planning on running 8-12 psi, how much should I retard the timing?
Timing is dead on!
But now since this is a 6 port turbo and I'm planning on running 8-12 psi, how much should I retard the timing?
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM