Aftermarket temp sender
#1
Aftermarket temp sender
https://www.rx7club.com/2nd-generation-specific-1986-1992-17/idea-water-temp-sender-location-turbo-cars-393210/
After reading this thread, I got to thinking as to where the best place to plumb in an aftermarket temp gauge sender would be. I initially thought it would be down on the side of the block but while fiddling with the sensor on the thermostat housing I realized that my aftermarket temp sender threaded in there perfectly. Elfking on this forum showed me his setup in which he utilized the 90 degree coolant hose for his aftermarket gauge.
Where is the most effective place to install a sender?
After reading this thread, I got to thinking as to where the best place to plumb in an aftermarket temp gauge sender would be. I initially thought it would be down on the side of the block but while fiddling with the sensor on the thermostat housing I realized that my aftermarket temp sender threaded in there perfectly. Elfking on this forum showed me his setup in which he utilized the 90 degree coolant hose for his aftermarket gauge.
Where is the most effective place to install a sender?
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM