2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

AC problems

Thread Tools
 
Search this Thread
 
Old Aug 4, 2006 | 02:52 PM
  #1  
13bturbofc's Avatar
Thread Starter
mmm doritos
Tenured Member: 15 Years
iTrader: (4)
 
Joined: Apr 2006
Posts: 2,107
Likes: 0
From: lancaster PA
Question AC problems

i have a 88 vert and im haveing a problem with water dumping onto the passenger side floor..im assuming that its from the ac...has anyone had this problem and if so how did you fix it?
Reply
Old Aug 4, 2006 | 02:55 PM
  #2  
J-Rat's Avatar
Alcohol Fueled!
Tenured Member 20 Years
iTrader: (2)
 
Joined: Jan 2002
Posts: 11,093
Likes: 2
From: Hood River oregon
Does it smell like coolant?
Reply
Old Aug 4, 2006 | 03:17 PM
  #3  
nopistons's Avatar
Senior Member
Tenured Member 10 Years
 
Joined: Oct 2001
Posts: 691
Likes: 0
From: new jersey
If it's condensate from the AC, there's a rubber tube under the car, just forward of the passenger's side footwell, about the diameter of your index finger, that's the condensate drain. CAREFULLY run a wooden dowel or something similar up the tube to unclog it. Don't get tough with it - You don't want to damage the evaporator inside.
Reply
Old Aug 4, 2006 | 10:28 PM
  #4  
13bturbofc's Avatar
Thread Starter
mmm doritos
Tenured Member: 15 Years
iTrader: (4)
 
Joined: Apr 2006
Posts: 2,107
Likes: 0
From: lancaster PA
ok ill try that ....i know its just water for sure so i guess the only thing it could be is the condensation....
Reply
Old Aug 4, 2006 | 10:51 PM
  #5  
jackhild59's Avatar
Rotary $ > AMG $
Tenured Member: 20 Years
iTrader: (7)
 
Joined: Apr 2005
Posts: 3,785
Likes: 30
From: And the horse he rode in on...
You can unstop the drain in several different ways. Try the following: Set the a/c heater fan to blow at the highest setting. Set the logicon to bring in outside air. Start the car. Have a friend help you and both of you slam the doors at the same exact time. The interior pressure you generate will sometimes blow open the drain. You can also have a third person slam the hatch at the same time.

If this doesn't work, you can snake the drain hose with a soft wire, you can blow into the drain tube with a compressor and an air blower attatchement. You can apply suction to the tube with a shop vac.

You may temporarily unstop the drain with the above methods, but ultimately, you need to open the box around the evaporator and clean it out. It is probably full of leaves and other debris. I have heard tails of dead animals like rats and birds, lizzards etc.
Reply
Old Aug 5, 2006 | 04:20 AM
  #6  
catchafox's Avatar
catchafox
Tenured Member 05 Years
 
Joined: May 2006
Posts: 38
Likes: 0
From: Akl New Zealand
using a zip tie is the easiest way, poke it from the engine bay into the drain in and out round and round if a big stream of water comes out sucess!
Reply
Old Aug 5, 2006 | 08:52 AM
  #7  
hondaslaya's Avatar
SA hole
Tenured Member 10 Years
iTrader: (3)
 
Joined: Aug 2004
Posts: 307
Likes: 0
From: Planet Piss
i resealed my winshield water was coming in from a small tear in the outside seal causing my trans computer and my ecu to short out
Reply
Old Aug 5, 2006 | 09:30 AM
  #8  
13bturbofc's Avatar
Thread Starter
mmm doritos
Tenured Member: 15 Years
iTrader: (4)
 
Joined: Apr 2006
Posts: 2,107
Likes: 0
From: lancaster PA
ok thanx for the tips....im wondering how i can remove the box around the evaporator to be able to clean it out?
Reply
Old Aug 5, 2006 | 05:28 PM
  #9  
jackhild59's Avatar
Rotary $ > AMG $
Tenured Member: 20 Years
iTrader: (7)
 
Joined: Apr 2005
Posts: 3,785
Likes: 30
From: And the horse he rode in on...
Originally Posted by 13bturbofc
ok thanx for the tips....im wondering how i can remove the box around the evaporator to be able to clean it out?
Use the FSM from the link in the FAQ.

Good luck.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
WyomingTII
2nd Generation Specific (1986-1992)
12
Sep 28, 2015 10:32 AM
lnlreaper
2nd Generation Specific (1986-1992)
2
Sep 27, 2015 09:59 AM
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM




All times are GMT -5. The time now is 06:20 AM.