RX7Club.com - Mazda RX7 Forum

2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

87 t2 why am i breaking up at 6000- 6500 then clearing up

Thread Tools
 
Search this Thread
 
Old May 19, 2008 | 04:30 PM
Share
  #1  
drifting in drifting's Avatar
drifting in drifting
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (11)
 
Joined: Feb 2008
Posts: 368
Likes: 0
From: drifting .pa
PA 87 t2 why am i breaking up at 6000- 6500 then clearing up
titles says it all hellpppp
Reply
0
Old May 19, 2008 | 09:40 PM
Share
  #2  
KhanArtisT's Avatar
KhanArtisT
Former FC enthusiast
Tenured Member 15 Years
iTrader: (2)
 
Joined: Dec 2004
Posts: 2,841
Likes: 2
From: Northern VA
I dunno but in my S5 NA I had a 7-8000 rpm hesitation that went way after I cleaned the grounds. Didn't even replace the bolt or any wires, just used an old *** wire brush and some WD40.
Reply
0
Old May 20, 2008 | 06:06 AM
Share
  #3  
drifting in drifting's Avatar
drifting in drifting
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (11)
 
Joined: Feb 2008
Posts: 368
Likes: 0
From: drifting .pa
ive cleaned all my grounds tried new coils plugs wires tps checked for vacum leaks but still cant figure it out
Reply
0
Old May 20, 2008 | 06:34 AM
Share
  #4  
MyRoTaRmOtOr's Avatar
MyRoTaRmOtOr
Full Member
Tenured Member 10 Years
 
Joined: Jan 2006
Posts: 199
Likes: 0
From: Midwest
overboosting?
Reply
0
Old May 20, 2008 | 04:04 PM
Share
  #5  
drifting in drifting's Avatar
drifting in drifting
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (11)
 
Joined: Feb 2008
Posts: 368
Likes: 0
From: drifting .pa
no more than ten pounds i have a fcd too and 255 walbro
Reply
0
Old May 20, 2008 | 04:11 PM
Share
  #6  
j9fd3s's Avatar
j9fd3s
Moderator
Community Builder
Liked
Loved
Community Favorite
iTrader: (3)
 
Joined: Mar 2001
Posts: 31,837
Likes: 3,234
From: https://www2.mazda.com/en/100th/
new plugs and wires fixed mine, ecu was way fat there

i had an fcon+gcc that let me lean it out there, that also fixed it
Reply
0
Old May 20, 2008 | 04:17 PM
Share
  #7  
drifting in drifting's Avatar
drifting in drifting
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (11)
 
Joined: Feb 2008
Posts: 368
Likes: 0
From: drifting .pa
well i have new plugs wires arent too far from it
Reply
0

Trending Topics

Old May 21, 2008 | 09:08 AM
Share
  #8  
Aaron Cake's Avatar
Aaron Cake
Engine, Not Motor
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
Check the condition of the connector on the CAS harness.

Are you running lean?
Reply
0
Old May 21, 2008 | 02:51 PM
Share
  #9  
FcZero's Avatar
FcZero
Junior Member
 
Joined: Oct 2007
Posts: 15
Likes: 0
From: tampa fl
have your battery load tested. its free at autozone. high rpm hesitations can sometime be caused by a bad battery...try it if you run out of ideas
Reply
0
Old May 21, 2008 | 08:54 PM
Share
  #10  
drifting in drifting's Avatar
drifting in drifting
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (11)
 
Joined: Feb 2008
Posts: 368
Likes: 0
From: drifting .pa
new battery and my afr are 11.5-12 at full boost somtimes dipping in the 10s at times given climate
Reply
0
Old May 22, 2008 | 09:43 AM
Share
  #11  
Aaron Cake's Avatar
Aaron Cake
Engine, Not Motor
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
AFRs in the tens will cause breakup. 12:0 is too rich at 6500 under boost.
Reply
0
Old May 22, 2008 | 03:49 PM
Share
  #12  
drifting in drifting's Avatar
drifting in drifting
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (11)
 
Joined: Feb 2008
Posts: 368
Likes: 0
From: drifting .pa
ok i was thinking that somewhat i have 680s in the secondaries and a stock ecu was gonna go to a rtek 2.1 a set 0f 720 or 1000s and a to4b
Reply
0
Old May 23, 2008 | 08:47 PM
Share
  #13  
drifting in drifting's Avatar
drifting in drifting
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (11)
 
Joined: Feb 2008
Posts: 368
Likes: 0
From: drifting .pa
bumpity
Reply
0
Old Jun 1, 2008 | 05:39 PM
Share
  #14  
drifting in drifting's Avatar
drifting in drifting
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (11)
 
Joined: Feb 2008
Posts: 368
Likes: 0
From: drifting .pa
so would 12.4 or so cause a rich miss for me. as my rpms go up my afr go down
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
[For Sale] Investment Cast 347SS Twinscroll EWG T4 FD Turbo Manifolds
Turblown
Vendor Classifieds
12
Oct 17, 2020 03:25 PM
Does this look like a fouled plug
Aramir
New Member RX-7 Technical
24
Oct 18, 2015 02:39 AM
Airpump Compatible EFR IWG Single Turbo System
Turblown
Single Turbo RX-7's
1
Sep 30, 2015 05:58 PM
Back to Subforum
2nd Generation Specific (1986-1992)
View Next Unread
Recommended suspension Touge/Drift




Advanced Search

All times are GMT -5. The time now is 09:55 PM.