850cc injectors
#3
Rotary Freak
iTrader: (1)
Join Date: Nov 2002
Location: Glyndon MN
Posts: 1,660
Likes: 0
Received 0 Likes
on
0 Posts
Marren fuel injection www.injector.com I ended up getting 890s since they were out of the 850s.
Trending Topics
#8
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: Jul 2003
Location: milpitas, CA
Posts: 1,133
Likes: 0
Received 0 Likes
on
0 Posts
where can i get 850-890 cc injecotrs. on www.injectors.com they are all low imped.
#11
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: Jul 2003
Location: milpitas, CA
Posts: 1,133
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by gergrx7
yes they are top feed, but 87.5 and lower are low imdependece and higher than that are high imdependence.
yes they are top feed, but 87.5 and lower are low imdependece and higher than that are high imdependence.
eric.
#12
I break Diff mounts
iTrader: (1)
You can use low impedance injectors in your harness.
You will need to put a 10ohm 10watt resistor in one fo the inecjtor wires (PER INJECTOR)
This drops the resistance down to acceptable ranges for the injectors.
This is what I have done on my car.
I have high impedance priamries and low impedance secondaries(planning on higher secondaries and high cc injectors are generally low imp)
You will need to put a 10ohm 10watt resistor in one fo the inecjtor wires (PER INJECTOR)
This drops the resistance down to acceptable ranges for the injectors.
This is what I have done on my car.
I have high impedance priamries and low impedance secondaries(planning on higher secondaries and high cc injectors are generally low imp)
#14
I break Diff mounts
iTrader: (1)
You can get them from radioshack.
Make sure they are 10ohm by 10 watt.
I think they were like 1-2 bux each.
Here is a pic of my setup.
The box with the duct tape on it is also from Radioshack.
I used it to isolate the resistors incase they create any heat and also to keep from being fucked up.
Make sure they are 10ohm by 10 watt.
I think they were like 1-2 bux each.
Here is a pic of my setup.
The box with the duct tape on it is also from Radioshack.
I used it to isolate the resistors incase they create any heat and also to keep from being fucked up.
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM