1990 Fc3s Mt
Thread Starter
Junior Member
Joined: Apr 2003
Posts: 41
Likes: 0
From: Ontario, Canada
when he turns the ignition the engine doesn't fully start up. in otherwords it doesn't gain running status...
perhaps you can tell me the difference between turning over and starting (i know a bit about cars but not much compared to most car people)
perhaps you can tell me the difference between turning over and starting (i know a bit about cars but not much compared to most car people)
turning over means the engine is turning. or moving. which you could hear. like crank crank crank. but not running.
that is not starting
if nothing happens at all when you try to start it. then it's not turning over. like battery 100% dead. all you get is a click. instead of the engine turning at all.
that is not starting
if nothing happens at all when you try to start it. then it's not turning over. like battery 100% dead. all you get is a click. instead of the engine turning at all.
Trending Topics
Try ATFing it and replacing the Plugs. check for ignition. Check compression with a commpression tester and removing the check valve needle. so it wont hold a reading. it should have 3 even bounces, on both rotors.
Thread Starter
Junior Member
Joined: Apr 2003
Posts: 41
Likes: 0
From: Ontario, Canada
Originally posted by sonic7
Try ATFing it and replacing the Plugs. check for ignition. Check compression with a commpression tester and removing the check valve needle. so it wont hold a reading. it should have 3 even bounces, on both rotors.
Try ATFing it and replacing the Plugs. check for ignition. Check compression with a commpression tester and removing the check valve needle. so it wont hold a reading. it should have 3 even bounces, on both rotors.
Thanks for the other advice as well.
Another question, does anyone know if the car should be running to replace the fuel pump regulator?
Thread
Thread Starter
Forum
Replies
Last Post







