Tachometer not reading at all
#1
Junior Member
Thread Starter
Join Date: Jun 2017
Location: Fort Worth
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Tachometer not reading at all
i have a 87 FC, N/A and I’ve recebtly done a rebuild and the tach worked fine at first. I drove it around a few times trying to break it in and I started t and get nothin from the tach or any other gauges , I know it is not a gauge cluster issue, I have resouldered my old cluster and replaced it with an OEM one. I did get the oil pressure and voltage to read by replacing a blown fuse in the kick panel but the rest of the fuses are fine and I can’t find a thread on this that talks about anything other than resouldering. Help would be appreciated,
Thanks
Thanks
#2
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
Clean ALL grounds on the Trailing coil and the bracket and chassis mounts that the coil attach to.
If that does not work try a "trick" with a Wire from the single bullet connector on the Leading coil attached to the Single wire with the bullet connector on the Trailing coil.
Hopefully you can make a patch wire with the proper connectors so you do not have to hack the wires.
If that does not work try a "trick" with a Wire from the single bullet connector on the Leading coil attached to the Single wire with the bullet connector on the Trailing coil.
Hopefully you can make a patch wire with the proper connectors so you do not have to hack the wires.
Last edited by misterstyx69; 12-21-17 at 11:40 PM.
Thread
Thread Starter
Forum
Replies
Last Post
EvilAreXeven
Power FC Forum
6
09-30-10 05:57 PM
juan0
2nd Generation Specific (1986-1992)
15
06-02-10 12:53 AM
veedubbed
2nd Generation Specific (1986-1992)
1
07-29-07 08:17 PM
MaczPayne
Microtech
4
06-26-07 10:08 PM
SoontobeLS1'd
2nd Generation Specific (1986-1992)
1
04-22-05 05:34 PM