Hi mates,
i want to ask you about the tightening torgue of the engine through bolts & the front pulley bolt & flywheel nut on the engine? i am at the end of my project (street 20b fd ) and i have a guestion if there is something special about the tightening torgue of the abone!i have already put the tightening torgue same as fd....
thank you
Dimitris

 

Anyone?????????

 

i could be wrong but the same applies to a 20b as a 13brew......... u can use the 13b`s specs

 

ok thanks.........

 

Yea but what about the smaller front tension bolts? They might have a differant spec because they only have to tighten a single rotor.

 

I was waiting someone (guru) from this forum like Evil to have a good answer......
Dimitris

 

I wad told, same as 13b-rew spec.
It was post here on the forum awhile back and I've acturally confirmed this with others.

 

Thanks......