Back to work on the 3 rotor!!!
#1
Back to work on the 3 rotor!!!
I finally got back to working on my conversion... Its been 3 years since I started the 3 rotor swap, lol. I was stupid and built other cars in the mean time (silvia and another 3rd gen)... I'm going to focus on the 3 rotor now and hopefully have it done by summer.
I painted the engine bay to match the outside of the car. Also, I pulled all of the wiring inside of the car and am going to run extensions to the headlights, blinkers, etc to keep it nice and clean in the engine bay. The fenders, headlights, and bumper are not bolted.. I just placed them there for the pic . Sorry for the crappy camera phone pics.
I painted the engine bay to match the outside of the car. Also, I pulled all of the wiring inside of the car and am going to run extensions to the headlights, blinkers, etc to keep it nice and clean in the engine bay. The fenders, headlights, and bumper are not bolted.. I just placed them there for the pic . Sorry for the crappy camera phone pics.
#6
Rotary Enthusiast
dude ...great to see youre finally going to round it up ....looking good and sharp !!!
BUT ........dude , that front has got to go .....other than that looking good , finish it !!
BUT ........dude , that front has got to go .....other than that looking good , finish it !!
#7
lol, I know it has to go... I hate it also! My other rx7 is for sale... As soon as that's gone I will completely focus on finishing this one! I need to get some pics of the roll cage I installed also (6pt autopower) once I'm done rewiring the interior and stripping off the sound deadening.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM