Hi all,

I'm soon going to be a owner of a rx-7 N/A from '89 (revised engine, bit of rust but none on the chassis for a mere 2200$).

And i was wondering if any of you had some good links on how to convert the engine to a 3-rotor twin-turbo instead of the 2-rotor N/A.

I'm thinking on having it modified while it is in the shop for having it de-rusted and repainted.

 

good luck........if you want a twin turbo 3 rotor you might as well buy a cosmo motor and install it in the NA.....it will be easier than what you are suggesting....I do not know of anyone that has done it but there are many that have swapped in the 20B in there.....try searching for a while and if you cannot find what you are asking then post here again.

 

Plain to spend 10X the cost the car for the conversion.

 

Moving to 20B Forum.

Also, once there, this thread will likely be closed by the moderator with a "read the FAQ" message.

 

Which part of the faq are you referring to then?

 

It's usually at the top of the page labeled "sticky"

 

https://www.rx7club.com/showthread.p...=1#post4270354




very top link

 

https://www.rx7club.com/forum/showthread.php?t=370451

Also, the 2nd gen FAQ has the generic rundown on 20B install.

 

ok my bad, me and my lack of observability only saw the general faq

Thnx for the replies, apparently everything i wanted to know, was stated in that faq