ok, just got back from iraq, and ive got a lot of stuff to do, but thats not the problem.

a while back, i started installing those ebay guages in my gsl. they were poor quality and i couldt figure out how to connect them, so back to stock, i decided. i performed the operation yesterday. unfortunately, when i was removing the tach needle, i met resistance, and ended up pulling out the pin that turns the needle as well as the needle. everythings back in order now, but the tach is behaving erratically, and i can wiggle it with my fingers.

can i fix it or do i need a new tach? and is it a new tach, or a whole new cluster?

 

not sure but pm me if you need a tach, i just broke the circuit board on a cluster and have all the gauges saved.