how come i haven't seen anyone here with an upper rear strut bar on their 1st gens? is it that terrifying to cut off a piece of your plastic interior??

but to all seriousness, if no one leads me to someone that actually sells this, i guess it's about time to bust out my MIG welder and hit up home depot.

sooo if you guys know any1 selling, please do lead me on.

thanks

-ray

 

I'm pretty sure I saw one for sale on the CP racing webpage right bellow the bolt in FB roll cage.

I personally think it would be easier to pick up some DOM pipe from a metal supply shop and fab one yourself as part of a welded in cage.

 

Ya CP racing makes one.

 

why.

 

it'll be a nice combo w/ your roll bar that's why

and plus, it'll help when i hit up the cali speedway for drift days

btw, i will check the CP website. thanks for the input 85rotarypower and supper

 

My input was small but helpful. I'll give ya there site: www.cpracing.ca . Just incase you didn't know it. CP racing sells a lot of stuff for the 1st gen.

 

i thought they just had the front bar...?

 

direct screenshot from their webpage FYI.

 

damm.. $125 is pretty much an arm and a leg.


so it's only CP racing that sells this product?

 

I had one welded in. Simple, effective, permanent.

 

$125 shipped isnt bad at all

 

Considering the load comes throught the floor just inside of the shock mounts, and the springs go to a "beam" under the floor, save your money for now. Put it into a full cage later. Oh wait I saw that it is for drifting too! Dude go for it, if your interested I have some JDM muffler bearings just for drifting and in a couple of weeks I'll have a shipment of special blinker fluid used by all the best drifters. Send your checks now to get on the waiting list Seriously, if your going drifting and expect to get a cage later, spend your dough on something that will give you more bang for your buck.

 

 

jb weld is not the same as MIG welding.

 

You mean like Gas, or tires?