Transmission rattle???
Transmission rattle???
I just put a new rear main seal, clutch, slave cylinder, throwout bearing, pressure plate, bearing cover gasket, and input bearing seal, and when the clutch is depressed it makes no noise... when i let off of the clutch in nuetral it rattles?? Could it be the throwout bearing, or the input bearing??
you didnt replace the piolt bearing? oh ur callin it the input?
i dont belive the tob can make a rattle noise maybe a wirring
check the shifter housing usally that needs transmission fluid myn ratled all the time
i dont belive the tob can make a rattle noise maybe a wirring
check the shifter housing usally that needs transmission fluid myn ratled all the time
Do you have a short shifter? Those are known to rattle.
Make sure you tighten down the shifter into the tranny properly, maybe its loose.
Pilot bearings make noise with the clutch in when they are bad ottherwise they aren't doing anything when the clutch is engaged.
Make sure you tighten down the shifter into the tranny properly, maybe its loose.
Pilot bearings make noise with the clutch in when they are bad ottherwise they aren't doing anything when the clutch is engaged.
Last edited by t_g_farrell; Jan 19, 2007 at 04:10 PM.
Trending Topics
The throwout bearing is the problem, i lost the 2 spring clips that hold the throwout bearing to the fork. so the throwout bearing is movin back n forth between the fork. Does anybody have any spare clips??? doubt it im in michigan though
Originally Posted by adidas_720
The throwout bearing is the problem, i lost the 2 spring clips that hold the throwout bearing to the fork. so the throwout bearing is movin back n forth between the fork. Does anybody have any spare clips??? doubt it im in michigan though
Originally Posted by adidas_720
well im sorry we cant all be RX7 doctors now can we nobodys perfect
It is a joke

Are you the same person as the thread starter?
Thread
Thread Starter
Forum
Replies
Last Post
MILOS7
3rd Generation Specific (1993-2002)
2
Oct 9, 2015 02:19 AM




