T II swap spedo gear question
#1
Junior Member
Thread Starter
T II swap spedo gear question
I am puting a T II S4 engine and trans in my 83 GLS. I did the shift box and rod stuff change but I am not sure if I need to use 83 or the T II speedo gear on the output shaft.
Thanks
Thanks
#2
FB+FC=F-ME
I just used the TII gear........I think I used the 1st gen cable.Its close enough to be safe,although tire/wheel and diff gear changes will mix things up a bit.
#3
I only have 1.3liters
iTrader: (2)
Join Date: Mar 2006
Location: Manchester, TN
Posts: 816
Likes: 0
Received 0 Likes
on
0 Posts
I know with the TII trans and my SE 4.08 gears, the speedo is pretty dead on. For yours to be right, you either need to:
A) Use the GSL Gear
B) Put 4:08s or 4:10s in it
C) Run shorter tires...
A) Use the GSL Gear
B) Put 4:08s or 4:10s in it
C) Run shorter tires...
#5
Rotary Enthusiast
iTrader: (12)
Join Date: Oct 2007
Location: Fort St John B.C. Canada
Posts: 871
Likes: 0
Received 0 Likes
on
0 Posts
I have a TII tranny in an 85 GSL and the speedo doesnt work, I didnt do the swap what should I look for and where should I look? Are TII tranny and the 85 speedo compatable? Do I have to change anything?
#6
If you pull the speedo at the tranny and cluster you can check to see if the speedo cable is broken. If the cable is fine you now have isolated the problem to either the gauge or the tranny.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM