Is this sound good or bad ?
#1
Is this sound good or bad ?
Hey guys, I am new to rotaries and I would like to know what do you guys think about the condition of this 12a that I bought some months ago and is still laying on the ground.
I am gathering all the stuff to swap that 12a into my '79 toyota starlet .
Anyways I read that if the sounds does not stop and alternates between the rear and front rotor means that the engine is fine, right? hehe
I did this short vid myself while doing the test at the same time
http://www.youtube.com/watch?v=s2rmRILlmT0
I am gathering all the stuff to swap that 12a into my '79 toyota starlet .
Anyways I read that if the sounds does not stop and alternates between the rear and front rotor means that the engine is fine, right? hehe
I did this short vid myself while doing the test at the same time
http://www.youtube.com/watch?v=s2rmRILlmT0
#2
Rotary Enthusiast
iTrader: (3)
sounds like you need to put sprak plugs in it then do the test. you are looking for 6 compression pulses out the exhaust ports. So if you turn the eccentric shaft over 3 full rotations and get 6 pulses for every half rotation then the motor should be in good shape. Also inspect the apex seal through the exhaust ports and ensure they have some spring to them too.
Thread
Thread Starter
Forum
Replies
Last Post