defiant13

iTrader: (-1)

Is there anyone out there, that is experienced, that can help me wire an s4 TII into an fb?
Stock TII ecu!!

Siraniko

iTrader: (13)

pm rotarydave2006

bad 83

iTrader: (3)

Yes........It will cost one Million dollars!!!!! Just kidding. I did mine myself, and eliminated all the "unneccesary" wiring I didn't need. Made things alot simpler when I installed it in the car. This is what wasn't "needed".




Mock up of the simplified harness before I installed it in the car.

Rx-7Doctor

iTrader: (13)

This is a archived thread that shows the swap from a N/A 13b into the fb

https://www.rx7club.com/1st-gen-archive-71/engine-documented-ecu-pinout-cut-list-13b-swap-820328/

Nef003

if i do not go standalone, i'll have to do this.. how painful is it? any tips?
I have no idea on how to get started.

I would like to know what pins to keep since i bet are going to be less than the ones removed. ;p

defiant13

iTrader: (-1)

thanks!

trochoid

iTrader: (6)

PM blyfly, he's in the process of installing a TII block, (NA atm), in his REPU. He stripped his harness down to the bare minimum and RotaryDave2006 helped him.