RX7 and Miata shift rod ends interchangable?
#1
Full Member
Thread Starter
RX7 and Miata shift rod ends interchangable?
I've been digging for a while and can't find any info on it, I'm talking about the shift rod ends, not the shift forks. The RX7 ones (two of the three and the selector lever) are NLA... has anybody had both transmissions apart and can tell me if I can swap them? Thanks.
The following users liked this post:
LEGALIZECHEY (12-09-20)
#3
Full Member
Thread Starter
Hmmm, I'll have to try and get my hands on some to find out for future reference, as I'm sure this issue will come up in the future. I've got two tranny's and both have more than the .8mm gap between the rod end and the selector lever, especially so on the 2-3 rod end. I'd foresee this as an issue others will encounter in the future. (Since they are NLA)
For now I welded the rod ends and ground them down back to spec, we'll see how long that lasts
For now I welded the rod ends and ground them down back to spec, we'll see how long that lasts
#5
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,900
Received 2,643 Likes
on
1,872 Posts
or you can weld up the originals and re-machine them
The following users liked this post:
LEGALIZECHEY (12-09-20)
Thread
Thread Starter
Forum
Replies
Last Post
JoeNoble
1st Generation Specific (1979-1985)
1
01-23-06 01:55 PM
GoRacer
3rd Generation Specific (1993-2002)
4
12-23-04 06:54 PM