Rats Nest
Thread Starter
Newbie
Joined: Dec 2002
Posts: 3
Likes: 0
From: Canada
Rats Nest
Hi everyone
I am quite new to this site and same goes for the rotary engine. I removed my rats nest and followed the tutorial as posted on this web site. However it made no mention of the afterburner vavle. If I plug off the vavle my car runs like **** so where exactly am I supposed to run a vacuum line to. If not do I just leave it open. If I leave 1 port open on the vavle the car runs ok except at higher steady rpm's. Help please.
I am quite new to this site and same goes for the rotary engine. I removed my rats nest and followed the tutorial as posted on this web site. However it made no mention of the afterburner vavle. If I plug off the vavle my car runs like **** so where exactly am I supposed to run a vacuum line to. If not do I just leave it open. If I leave 1 port open on the vavle the car runs ok except at higher steady rpm's. Help please.
Joined: Oct 2001
Posts: 6,444
Likes: 0
From: Fort Branch, Indiana
You remove it and cap and seal the entire opening, use 1/4 inch AL cut to fit the hole made in its abscense. Hope you removed the cats too when you did all of this...
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
Jun 3, 2024 03:25 PM
LongDuck
1st Generation Specific (1979-1985)
12
Oct 7, 2015 08:12 PM