neutral safety switch
#1
Yo C/O
Thread Starter
Join Date: Mar 2001
Location: Vineland, NJ
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
neutral safety switch
where is the neutral safety switch on an 85 12a, i can't get the car to turn over and i know the battery, starter, battery cables , ground are fine. any ideas? thanks, vic
#2
Lapping = Fapping
iTrader: (13)
Try your ignition switch too. Either that or your solenoid wire came off. It happend on my friend's 13B. Just lightly squeeze the quick disconect terminal and put it back on. It most likely won't come off by itself in the future. Works every time, unless you've botched the wiring and there isn't enough slack anymore. Good luck.
#3
Yo C/O
Thread Starter
Join Date: Mar 2001
Location: Vineland, NJ
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
update...
i got the starter to crank i did few tests w/ the tester and everything tested good. got in the car, turned the key and i got this big grin on my face ,it was music to my ears. the starter cranked, i could actually hear the compression in the motor. it was great. now i just have to get it to actually start. almost everything under the hood is new so alittle tweaking is all it should take, i hope. the reason it wasn't cranking in the first place is the nuetral safty switch, or maybe the inhibater switch because the gear shifter has to be in the exact spot or it won't start. i will have to adjust it when my back stops hurting from today. i had a fusion done a few months ago and it really hurts when i do anything. but i'm getting there i want to at least drive it once before winter..... the cool part is i have a carbon fiber disk..vic
i got the starter to crank i did few tests w/ the tester and everything tested good. got in the car, turned the key and i got this big grin on my face ,it was music to my ears. the starter cranked, i could actually hear the compression in the motor. it was great. now i just have to get it to actually start. almost everything under the hood is new so alittle tweaking is all it should take, i hope. the reason it wasn't cranking in the first place is the nuetral safty switch, or maybe the inhibater switch because the gear shifter has to be in the exact spot or it won't start. i will have to adjust it when my back stops hurting from today. i had a fusion done a few months ago and it really hurts when i do anything. but i'm getting there i want to at least drive it once before winter..... the cool part is i have a carbon fiber disk..vic
Thread
Thread Starter
Forum
Replies
Last Post
REX7&Z32TT
New Member RX-7 Technical
5
09-09-15 05:16 AM
rx8volks
Canadian Forum
0
09-01-15 10:46 PM