Hello Everyone,

I'm in the process of finally getting everything put back on my engine, but unfortunately my notes on the vacuum lines have been lost. I trying to go by the manual, but the drawings are hard to make out and difficult to understand.

Here's where I'm stuck at the moment. On the front of the dynamic Chamber there are 4 vacuum nipples in a vertical row. The question I have concern the bottom two. The third one looks as if it goes from the nipple to a circular connector that then solid into 4 lines. Where do these go? I have gathered that they might go to the oil metering lines. If this is true, I've ditched my omp and I'm going to pre mix. Can I cap of that nipple and discard the circular connector and lines? If not, where does it go?

The second question is the 4th or bottom nipple. The diagram shows that it goes under the intake manifold. The only nipple I can see the is going to the cold start assist device. I've decided to delete that as well since I live in Florida. If this is correct I should be able to cap that as well since I've already capped the nipple at the cold start assist.

Any help would be appreciated.