Fresh Rebuild Start...
#1
Fresh Rebuild Start...
I am almost ready to start my freshly rebuilt street ported 12A... I am going to pre-mix this one.
Are there any suggestions out there for a fresh start? I plan to use a dropper to feed the mix oil for the first start.
What pre-mix ratio should I use?
Thanks
Are there any suggestions out there for a fresh start? I plan to use a dropper to feed the mix oil for the first start.
What pre-mix ratio should I use?
Thanks
#3
Senior Member
iTrader: (2)
Isn't it just as easy to answer the question as it is to tell them to search? The thread has already been started you might as well help.
For the first start: put a capful of straight 2-cycle directly in each barrel. Premixing ratio is around 1 oz tc-w3 oil per gallon of gasoline.
For the first start: put a capful of straight 2-cycle directly in each barrel. Premixing ratio is around 1 oz tc-w3 oil per gallon of gasoline.
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
Blk 93
3rd Generation Specific (1993-2002)
7
09-28-15 01:45 PM