Dual alternator belt pully
#1
Full Member
Thread Starter
Dual alternator belt pully
IS Slipping and is wearing out belts. This is the one from banzai racing. Is there a way to prevent this? I didn't want to get the belts super tight in fear that I would damage the water pump. Probably just run with one belt?
Or is there a better alternative?
Or is there a better alternative?
#3
Waffles - hmmm good
iTrader: (1)
You just need to make sure the deflection is about 1/2 inch or less when you push on it. Also
new belts will need to be retighten after a few hours of runtime. They will stretch a bit.
That Banzai adjustable bracket is slick!
new belts will need to be retighten after a few hours of runtime. They will stretch a bit.
That Banzai adjustable bracket is slick!
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic electric water pump control "map"
sherff
Adaptronic Engine Mgmt - AUS
6
11-24-15 06:00 PM