Dellorto carb parts
#1
Senior Member
Thread Starter
Join Date: Apr 2004
Location: South Jordan UT
Posts: 453
Likes: 0
Received 0 Likes
on
0 Posts
Dellorto carb parts
I've run into an impassible problem with my Nikki so I'm gonna try to get two junk dellorto's into one good carb. Where can I get parts? The only place I can find them is from italy. If anyone has any domestic sources, I could use a rebuild kit. Thanks for any help
#2
Jolly Green Giant
iTrader: (1)
Join Date: Feb 2008
Location: San Antonio, TX
Posts: 509
Likes: 0
Received 0 Likes
on
0 Posts
Dell 48 Master Rebuild Kit:
http://cbperformance.com/catalog.asp?ProductID=516
All of CB Performances stuff:
http://cbperformance.com/category.asp?categoryid=6
England but still a good source:
http://www.dellorto.co.uk/merchandis...artsectionID=9
Ebay:
http://shop.ebay.co.uk/i.html?_nkw=dellorto+dhla%29
http://cbperformance.com/catalog.asp?ProductID=516
All of CB Performances stuff:
http://cbperformance.com/category.asp?categoryid=6
England but still a good source:
http://www.dellorto.co.uk/merchandis...artsectionID=9
Ebay:
http://shop.ebay.co.uk/i.html?_nkw=dellorto+dhla%29
#3
Senior Member
Thread Starter
Join Date: Apr 2004
Location: South Jordan UT
Posts: 453
Likes: 0
Received 0 Likes
on
0 Posts
That's the mother lode of parts and I'm sure that will suffice. I noticed that you got a 48mm for your info. Is the RB dellorto a 48mm? I thought it was a 40mm but it's been a while since I paid attention.
#5
Junior Member
Join Date: Apr 2010
Location: New Jersey
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
I was kinda disappointed with the rebuild kit I got from CB -- it had duplicates of some gaskets, and was missing others. Also, the carb-manifold gaskets they sent me were for a 45, even though I ordered a rebuild kit for a 48. I have read elsewhere that the kits from www.dellorto.co.uk and Italy are the way to go. Best of luck,
-S
-S
#6
Say What?
Join Date: Jun 2007
Location: Oak Harbor,WA and Santa Maria, CA
Posts: 1,239
Likes: 0
Received 0 Likes
on
0 Posts
https://www.rx7club.com/1st-generation-specific-1979-1985-18/dellorto-48-dhla-swap-13b-12a-not-56k-friendly-773154/
read my thread...i used the 45 rebuild kit, when i needed it cbperformance said they did not sell the 48 kit anymore and the 45 is similar...i did have to create a gasket..its in the thread
read my thread...i used the 45 rebuild kit, when i needed it cbperformance said they did not sell the 48 kit anymore and the 45 is similar...i did have to create a gasket..its in the thread
#7
Senior Member
Thread Starter
Join Date: Apr 2004
Location: South Jordan UT
Posts: 453
Likes: 0
Received 0 Likes
on
0 Posts
Thanks to all for the info. I've ordered a rebuild kit for a 48mm and hopefully, I'll have a running car soon. I'll post back as far as the results.
Thread
Thread Starter
Forum
Replies
Last Post