Dellorto carb parts
 

I've run into an impassible problem with my Nikki so I'm gonna try to get two junk dellorto's into one good carb. Where can I get parts? The only place I can find them is from italy. If anyone has any domestic sources, I could use a rebuild kit. Thanks for any help

Dell 48 Master Rebuild Kit:
http://cbperformance.com/catalog.asp?ProductID=516

All of CB Performances stuff:
http://cbperformance.com/category.asp?categoryid=6

England but still a good source:
http://www.dellorto.co.uk/merchandis...artsectionID=9

Ebay:
http://shop.ebay.co.uk/i.html?_nkw=dellorto+dhla%29

That's the mother lode of parts and I'm sure that will suffice. I noticed that you got a 48mm for your info. Is the RB dellorto a 48mm? I thought it was a 40mm but it's been a while since I paid attention.

I was kinda disappointed with the rebuild kit I got from CB -- it had duplicates of some gaskets, and was missing others. Also, the carb-manifold gaskets they sent me were for a 45, even though I ordered a rebuild kit for a 48. I have read elsewhere that the kits from www.dellorto.co.uk and Italy are the way to go. Best of luck,

-S

https://www.rx7club.com/1st-generation-specific-1979-1985-18/dellorto-48-dhla-swap-13b-12a-not-56k-friendly-773154/

read my thread...i used the 45 rebuild kit, when i needed it cbperformance said they did not sell the 48 kit anymore and the 45 is similar...i did have to create a gasket..its in the thread

Thanks to all for the info. I've ordered a rebuild kit for a 48mm and hopefully, I'll have a running car soon. I'll post back as far as the results.