1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

anyone know wat this guy is talkin about?

Thread Tools
 
Search this Thread
 
Old Mar 7, 2004 | 09:06 AM
  #1  
timmya2's Avatar
Thread Starter
Banned. I got OWNED!!!
 
Joined: Nov 2002
Posts: 1,068
Likes: 0
From: Pensacola
anyone know wat this guy is talkin about?

hi i just put up a post on ausrotary.com

i was getting strong rotary smell ie heaps of fuel when the car is running after i put the new weber in..


heres the thread

http://ausrotary.dntinternet.com/for...ic.php?t=25515

anyone know wat KYPREO is pointing out?

a pic would be very very helpful.. if anyone has one of this "crankcase ventilation hoses and charcoal canister "

cheers
Reply
Old Mar 7, 2004 | 07:09 PM
  #2  
timmya2's Avatar
Thread Starter
Banned. I got OWNED!!!
 
Joined: Nov 2002
Posts: 1,068
Likes: 0
From: Pensacola
anyone?
Reply
Old Mar 7, 2004 | 07:25 PM
  #3  
mazdaverx713b's Avatar
Have RX-7, will restore
Veteran: Army
Tenured Member: 20 Years
Loved
Community Favorite
iTrader: (91)
 
Joined: Oct 2003
Posts: 22,577
Likes: 1,273
From: Ohio
the crankcase ventilation hose and canister traps fuel vapors instead of letting them seep and cause this smell you speak of. the canister is located on the passenger side, next to the strut tower. it has two hoses that connect to it. i wish i had a pic. i could not access your page, so i hope this info will be helpful.
Reply
Old Mar 7, 2004 | 07:26 PM
  #4  
Siraniko's Avatar
RX for fun
Tenured Member 15 Years
iTrader: (13)
 
Joined: Aug 2001
Posts: 15,926
Likes: 25
From: Socal
Total BS in my opinion. As you may know by now, all my cars got a 48 IDA.. All you need is a fuel line to go to carb, no need for return (but it would be nice to have one). As long as there is no gas leak (float set correctly, no other leaks), then there should be no gas smell (except for raw gas at high RPM). Other than that, it there should be no smell at idle. WEll running rich is a different story. I like to run my engine rich.
Reply
Old Mar 8, 2004 | 12:34 AM
  #5  
timmya2's Avatar
Thread Starter
Banned. I got OWNED!!!
 
Joined: Nov 2002
Posts: 1,068
Likes: 0
From: Pensacola
i aint running rich..

i thought i was.. but i just put the idle down and is now idling perfectly at around 800 rpm and operating temerature.

its a bit low when cold..

ill try to take a picture of my engine bay so u guys can tell me if theres any leaks

cheers
Reply
Old Mar 8, 2004 | 01:09 AM
  #6  
timmya2's Avatar
Thread Starter
Banned. I got OWNED!!!
 
Joined: Nov 2002
Posts: 1,068
Likes: 0
From: Pensacola
ok here are the pics of my engine bay setup..
can someone point out where it is.. or anythign wrong with it that could be affecting that smell







Reply
Old Mar 8, 2004 | 01:10 AM
  #7  
timmya2's Avatar
Thread Starter
Banned. I got OWNED!!!
 
Joined: Nov 2002
Posts: 1,068
Likes: 0
From: Pensacola
you may want to save it into yur hard drive so you can zoom in.. if the pic is too small

cheers
Reply
Old Mar 8, 2004 | 03:28 AM
  #8  
Rotor13B's Avatar
Wassup!!
Tenured Member 15 Years
 
Joined: Jul 2001
Posts: 1,081
Likes: 1
From: Longmont Co.
It's on your passenger side fender with the two hoses coming out of it, or should have two hoses anyway. <see second to the last pic posted>
Reply
Old Mar 8, 2004 | 03:50 AM
  #9  
timmya2's Avatar
Thread Starter
Banned. I got OWNED!!!
 
Joined: Nov 2002
Posts: 1,068
Likes: 0
From: Pensacola
passenger side meaning drivers side? (im from australia right hand drive)

and did u mean the second last pic?


u can right click--> properties and copy and paste the URL.. so i know exaclty which pic u are talkin about

cheers mate
Reply
Old Mar 8, 2004 | 07:12 AM
  #10  
deeman111's Avatar
Full Member
Tenured Member 05 Years
 
Joined: Jul 2002
Posts: 177
Likes: 0
From: Perth, Western Australia
hey its on the passengers side, i dont have one but ive seen where there supposed to go.... just plugging the holes will stopn the smell, but if you have the cannister then you might as well use it

-James
Reply
Old Mar 8, 2004 | 07:35 AM
  #11  
timmya2's Avatar
Thread Starter
Banned. I got OWNED!!!
 
Joined: Nov 2002
Posts: 1,068
Likes: 0
From: Pensacola
dude.. the problem is.. i dont know wat the canister is.. or wat hoses that guys is talking about..

i am a complete noob..

pls help

cheers
Reply
Old Mar 8, 2004 | 08:02 AM
  #12  
Siraniko's Avatar
RX for fun
Tenured Member 15 Years
iTrader: (13)
 
Joined: Aug 2001
Posts: 15,926
Likes: 25
From: Socal
THe only time that I experienced gas smell in the engine compartment is when my tank's breather line was clogged. when its clogged, the pressure will built up and the gas will go up thru the return line. It happened after the FB sat for several months while the engine was out for porting. When I got it back on the road, I noticed gas smell too when the tank is 100% full. I just cleaned out the check valve and other lines and the smell went away.
Reply
Old Mar 8, 2004 | 08:12 AM
  #13  
Rotor13B's Avatar
Wassup!!
Tenured Member 15 Years
 
Joined: Jul 2001
Posts: 1,081
Likes: 1
From: Longmont Co.
This pic, passenger side, (drivers side U.S.) http://chubby.nameserve.org/~timmya/100_2778.jpg
Reply
Old Mar 8, 2004 | 08:54 AM
  #14  
timmya2's Avatar
Thread Starter
Banned. I got OWNED!!!
 
Joined: Nov 2002
Posts: 1,068
Likes: 0
From: Pensacola
wacky where is this breather line located? any pics of it?
(my tank is never full so i doubt its that but worth a try anyway)
thanx man..

and rotorb.. i dunno which two hoses in that pic u are refering to.. any chance of highlighting it with paint or sumthing?

cheers to everyone who is helping a poor n00bie out i know it muist be frustrating.. but i might get cancer if i dont fix this soon becauise the smell is really heavy and it getting into my clothes and everything


cheers

Last edited by timmya2; Mar 8, 2004 at 08:57 AM.
Reply
Old Mar 8, 2004 | 09:24 AM
  #15  
RX7145's Avatar
-SE with Mods
Tenured Member 10 Years
iTrader: (1)
 
Joined: Jul 2001
Posts: 562
Likes: 0
From: Ohio, Columbus
Is that an AUTO
Reply
Old Mar 8, 2004 | 09:38 AM
  #16  
timmya2's Avatar
Thread Starter
Banned. I got OWNED!!!
 
Joined: Nov 2002
Posts: 1,068
Likes: 0
From: Pensacola
yes
Reply
Old Mar 8, 2004 | 11:48 AM
  #17  
GOOFYROTOR's Avatar
cams pistons valves
Tenured Member 05 Years
 
Joined: Jun 2003
Posts: 3,004
Likes: 0
From: LA
the above is true. theres also,
check the rear tail lights, if the nuts are loose the fumes leak in from the trunk and the weather stripping around the trunk.
holes around the fire wall and trunk.
Reply
Old Mar 8, 2004 | 03:56 PM
  #18  
timmya2's Avatar
Thread Starter
Banned. I got OWNED!!!
 
Joined: Nov 2002
Posts: 1,068
Likes: 0
From: Pensacola
yep.. but i need to know where the two hoses are and where the breather line located so can give those a go too
Reply
Old Mar 8, 2004 | 11:00 PM
  #19  
timmya2's Avatar
Thread Starter
Banned. I got OWNED!!!
 
Joined: Nov 2002
Posts: 1,068
Likes: 0
From: Pensacola
bump
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Tylerx7fb
1st Generation Specific (1979-1985)
39
May 27, 2019 12:45 PM
Kruel13
1st Generation Specific (1979-1985)
24
Sep 16, 2015 09:08 AM
Clacor
Single Turbo RX-7's
0
Aug 14, 2015 09:17 AM




All times are GMT -5. The time now is 03:44 PM.