85 Oil Cooler (Air vs Water) Conversion Question
#1
Junior Member
Thread Starter
Join Date: Jul 2001
Location: Fort Walton Beach FL
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
85 Oil Cooler (Air vs Water) Conversion Question
I have the 13B Monster Oil to Air Cooler ready for install on my 85. Will it work on my 85 plumbed to the currently blocked passage. I have a racing beat oil filter conversion and the short stand filter mount from and earlier model, and all the plumbing to fit the new cooler.
Is it really that simple???
I figure the front motor outlet to the top inlet of the big cooler, and the rear motor passage to the side?
Please advise.
Email or post
Bonjo2@earthlink.net
Is it really that simple???
I figure the front motor outlet to the top inlet of the big cooler, and the rear motor passage to the side?
Please advise.
Email or post
Bonjo2@earthlink.net
#3
Junior Member
Thread Starter
Join Date: Jul 2001
Location: Fort Walton Beach FL
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Thanks
It's been a while. The racing beat unit is only a block for temp and pressure senders and mounts to stock oilt filter stand, not a conversion kit as previously stated.
Do you know if it's O.K. to mount the oil cooler at say alternator height?
Thanks for your reply.
Do you know if it's O.K. to mount the oil cooler at say alternator height?
Thanks for your reply.
#4
I can has a Hemi? Yes...
iTrader: (2)
Re: Thanks
Originally posted by Bonjo
It's been a while. The racing beat unit is only a block for temp and pressure senders and mounts to stock oilt filter stand, not a conversion kit as previously stated.
Do you know if it's O.K. to mount the oil cooler at say alternator height?
Thanks for your reply.
It's been a while. The racing beat unit is only a block for temp and pressure senders and mounts to stock oilt filter stand, not a conversion kit as previously stated.
Do you know if it's O.K. to mount the oil cooler at say alternator height?
Thanks for your reply.
Racing Beat Remote Oil Filter
But honestly, it could be any, doesn't have to be RB.
The Oil Cooler lines are High pressure, so mounting them at alternator height shouldn't be a problem.
Thread
Thread Starter
Forum
Replies
Last Post