I went looking around the wrecker today to see if there was a 1st gen with a rear spoiler. To no avail..... There was tho a 2nd generation factory spoiler. I am thinking of trying to make it work.... Has anyone done this before, or seen it? how does it look?

 

Nobody? I'll try and find a picture of one...

 

you can make it work i'm sure. if anything, you may just have to cut some out of the center area and fab it back together. then just start test fitting. take a pic.

 

Well thats a picture of the one I am looking at getting.. what do you guys think it would look like on a 1st gen...


http://www.cardomain.com/memberpage/555919

 

Probably similar to the Mazdatrix GTU spoiler, only less well fitting.

 

hmmm, sounds like a job for PHOTOSHOP!

 

I don't have photoshop, nor would I know how to use it.

 

Yep, it looks like the GTU spoiler, and yes it probably will fit much worse.... But I will only be paying 20 bux Canadian, which is like 15 bux US.... pretty cheap...

 

i dont like the 2nd gen spoiler mine isn't stock i dont think maybe it is but i like the looks of it

 

i did it i did it... We just put a S4 turboII wing on my buddy's car today. It only took like 30 minutes, real simple. I'm doing mine tommarrow, it almost looks like it belongs on the car stock. It sits at a good angle and doesn't block the hatch. I will post some pix tommarrow

 

sweet

 

what? hmmmm. yea i'll definately need to see some pics. hahaha

 

i know someone put a stock fc fiberglass wing on an fb and it didnt quite fit perfectly, but it was close, mazdatrix does sell the GTU fc stlye wing specifically designed for our cars..

www.mazdatrix.com

 

i think mark perez did it. pm him. i saw his car its sweet.

 

When I was stationed down in NC there was a shop with several 1st gens sitting out front (the shop was in hampstead). one of the 1st gens had a FC spoiler on the back and it looked really nice like it came from the factory.

 

A friend of mine has installed a stock FC rear spoiler on his FB. It was made to fit, some material was shaved off and the antenna hole was filled in, since the rear of the 1st gen is at an angle whereas the 2nd gen is flat.
Mark Ps wing is not a factory piece but a Kanimari for a 2nd gen glassed onto his 1st gen.

 

Thats the only real concern I have is the slope on the back of our cars, and the lack of one on the 2nd gen...but I am sure it can be done...

 

www.selectmaz.com.au

Nicest rear spoilers I've seen.

 

Yeah, thats right. it's not from a TII, it has one piller in the center and the sides are longer. 3/4 towards the roof line, from there i molded-in the sides with the roof line. the whole thing wraps around the whole back end of the car. looking at the car from the side it makes a flat line and the rear hatch window 'sinks' below
the spoilers flat lines. the sides, to make it look a bit better are molded-in so it doesn't have that 'bolted-on' look. the lower part of sides, the lower line disappears into the fender all there is ,is just one flat line.. it looks okay, and it can be done.

 

does anyone have a pic of one installed?

 

damn i love your rims, i have the exact same rims on my car...sweet i thought that i was the only one with cragars on...