1980 w/13B 4 port
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: Mar 2002
Location: Las Vegas, NV
Posts: 4,236
Likes: 0
Received 0 Likes
on
0 Posts
1980 w/13B 4 port
I got a 1980 Rx-7 w/13B 4 port installed. Can't get my eng temp gauge to work. anyone have this setup.. Can you give me some advise? Below oil filter should be eng temp sensor right? Can i ground out harness wire and gauge will move to make sur ei got right wire??
Thanks, Gonzz
Thanks, Gonzz
#5
Blood, Sweat and Rotors
iTrader: (1)
on a 12a and a rotary pickup 13b 4port i worked on last week theres a big brass electric sender with a fat round end that threads into the rear side housing. on the fat round end there is little round circle protusion. u slide the female connector (that looks like it's for a blade connector) right onto that little round circle protusion.
now on 12a water temp is on the same rear side housing and is a little spud that you pop a female roundy connector onto. don't remember about the 13b 4port but i'd bet its similar.
if ur going to sevenstock tomorrow just call me on my cell and i'll come over and help out. later gonz!
-brad-
now on 12a water temp is on the same rear side housing and is a little spud that you pop a female roundy connector onto. don't remember about the 13b 4port but i'd bet its similar.
if ur going to sevenstock tomorrow just call me on my cell and i'll come over and help out. later gonz!
-brad-
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM