just want to bitch
#1
recycled teenager
Thread Starter
Join Date: Feb 2004
Location: Jackson MI USA
Posts: 837
Likes: 0
Received 0 Likes
on
0 Posts
just want to bitch
The idiot that located the heat sensor ,must have had very small hands ,and endless patience, still looking for the other idel control screw. But I will find the rotten thing. Bob
#2
recycled teenager
Thread Starter
Join Date: Feb 2004
Location: Jackson MI USA
Posts: 837
Likes: 0
Received 0 Likes
on
0 Posts
bitch bitch bitch
Hi I got the temp sensor out and a new one in, still dont work must ba a wire. but I did find the hard to find second mixturre screw,and it was painted red. took me two days to find it. Bob
#5
Rotoholic Moderookie
iTrader: (4)
Sterling and rat's nest removal... I can get to both my idle speed and mixture screws with absolutely zero problem (which is great in the spring/fall when temps change and I want to bump the idle up or down a bit or smooth it out).
Not sure which heat sensor you're talking about... But any time I have trouble taking a part off I try to figure out how it got on there. For example the clutch master cylinder was installed *before* the dash was.. lucky bastards doing the assembly.
What's broken that's got you changing a heat sensor? Gauge?
Jon
Not sure which heat sensor you're talking about... But any time I have trouble taking a part off I try to figure out how it got on there. For example the clutch master cylinder was installed *before* the dash was.. lucky bastards doing the assembly.
What's broken that's got you changing a heat sensor? Gauge?
Jon
Thread
Thread Starter
Forum
Replies
Last Post
Grimlock
2nd Generation Specific (1986-1992)
3
03-11-02 11:13 AM