Gslse tps adjustment problems
#1
Junior Member
Thread Starter
Gslse tps adjustment problems
So im trying to adjust the tps by the shop manual. Tested the tps with an ohm meter, and it is working properly. I made the test light. Tested it on the battery so I know it works. Following the correct procedure from the book. Checking from the green clip by the air box I am getting no lights no matter how I adjust the screw. Not sure if this helps but with a test light there is power going to all wires from the green clip. Anyone know where to go from here?
#2
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,827
Received 2,595 Likes
on
1,843 Posts
i would either unbolt the TPS or open the throttle by hand, and push the plunger in manually, and see if there is a spot where only 1 light is on. if yes, then its working properly, and you just need to find the adjustment, if no, then TPS is most likely borked.
i should point out that the engine needs to be warn to adjust the TPS, the cold idle thing works by opening the throttle
i should point out that the engine needs to be warn to adjust the TPS, the cold idle thing works by opening the throttle
Thread
Thread Starter
Forum
Replies
Last Post
vworley
1st Generation Specific (1979-1985)
14
08-03-09 09:00 AM