Wolf 3D wolf 3d
06-10-03, 09:51 PM
#1
Full Member
Thread Starter
Join Date: Mar 2003
Location: Montana
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
wolf 3d
I need to know if anyone else has a wolf 3d ver.3.1. I need to know what your starting fuel and ignition settings are. I can't getg my motor to start but after it finally starts by pulling it behind a truck. It runs fine and idles at 890 fine. Please help me.
06-11-03, 06:40 PM
#4
Rotorhead
Join Date: Feb 2001
Location: Charlottesville, Virginia, USA
Posts: 9,136
Likes: 0
Received 39 Likes
on
33 Posts
Originally posted by rxsevn89
For t2 It has a full race ported 3mm seals and a t-60 tec turbo.
For t2 It has a full race ported 3mm seals and a t-60 tec turbo.
Newly-built engines generally require a higher cranking speed. How many rpm's are you getting when you engage the starter?
Do you have your Cold Enrich set to 0, and are you starting with a low Cranking Fuel Rate and bumping it up as you crank the engine?
06-11-03, 06:56 PM
#5
Full Member
Thread Starter
Join Date: Mar 2003
Location: Montana
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
I finally got it to start. If I have any more problems I will contact you. Thank you alot. Its nice to have some to help me when I need it. This is a new expirance for me.
Thread
Thread Starter
Forum
Replies
Last Post
