Wolf 3D wolf 3 d engine management tuning
#1
Newbie
Thread Starter
Join Date: Feb 2006
Location: EL DORADO HILLS CA.
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
wolf 3 d engine management tuning
motor goes flat at 4500 under heavy load any feed back 87turbo 2 street port 800 and 1600 injecters aerotech fuel pump
#2
Rotary Enthusiast
Join Date: Feb 2004
Location: North Queensland Australia
Posts: 778
Likes: 0
Received 0 Likes
on
0 Posts
Make sure that if your staged injectors skip setting is 0 that you use a maximum of 50% duty on the setup for the secondries. This is because if the skip is set to 0 it fires on every event(rotor1 and 2 TDC?) which is double firing. If your skip is set to 1 it only fires once per revolution. If you go above 50% with skip set to 0 when your pulse width hits about 5.6 ms and you will miss a fuel pulse. This usually happens about 4500 rpm for me. With skip set to 1 you can stage up to 100%
Regards
Michael Smith
Regards
Michael Smith
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
stickmantijuana
MoTeC
5
09-10-15 07:58 PM
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM