what exactly is the difference? i'm using my map sensor for load % but i normally idle at like 25% load while normal. and i put about 13psi on the wolf psi and turn it to wolf and it drops down to about 17% is it just map voltages/reads? and is there a way to recalibrate/modify the map voltages? cause on normal i only got up to 89% load and on wolf psi i got to 103% which still isn't maxed (107%).. i've seen calibration tables when using the pc. but I have no idea what the voltages are. etc.

thanks,
Chase

 

OK when you reset your map to 13psi @ 100% load you make the fuel calibration much finer by condensing the map. The extra 7 percent is actually there to cope with the ram air effect and greater air pressure and gives a little safety buffer. If I was seeing 103% I would reset my map to 15psi. But thats just a personal choice. I run mine unadjusted 20psi = 100% 23 psi 107 % The voltages ??? In what section of the map?

Cheers
Michael Smith