Net Seven

iTrader: (5)

I got my wolf3d all wired up and found out my starter is bad so I cant try to start up the car yet. When I have my hand controller hooked up and I turn the key on, it says "Check Wiring, Ignition Sense Pin Low, but ECU is on". Does anyone have an idea why im getting that?

Net Seven

iTrader: (5)

Nevermind in the book it says its caused by the turbo timer loop back plug not being installed. Meaning if I dont got a turbo timer hooked up, then I gatta have the loop back plug in..... alright im ganna go try it out see what happends

CrackHeadMel

iTrader: (2)

I had my wolf half wired up and i gave it power, i got the same error, shut it off, threw in the loopback and the error went away

-Jacob

Michael Smith

My home built turbo timer does the same causing the ign sense low alarm until it turns the ignition back on. It has a delay of 2 seconds before all ignition power is supplied. I had to do this because of some strange intermittent failure to run the timer at turnoff.
Michael Smith

pilot

I have been watching images of Wolf´s turbo timer and it seems that it is a very simple thing. It looks a "simple" relay or array of them. Is there anyone who knows this? I´d like to build it.

Regards.