maduhbee

I saw a Spirit R gauge cluster with MPH on it... wanna know where i can get one!!!!

btw, i think i'm settling for the PFC + commander, + tuning. it all comes out to be 1100 OTD. everything brandnew, and work done by XS engineering. good yes?

r0t0r-rooter

PFC + tuning from XS for $1100? That's unusually cheap. From what I remember, they charged $150/hr for the dyno tuning, and stock twin set ups usually required ~ 4 hrs. Singles ~ 8 hrs. This is in addition to the pre-dyno checkup of your car. XS also used to charge a $45 hook-up-to-the-dyno fee, but maybe they waive it since you pay so much for everything else....

maduhbee

don't forget that's also with the commander too haha... what about the spirit-R gauge cluster?

quicksilver_rx7

You can't get a Spirit R gauge cluster that reads MPH. They use KPH in Japan. Both U.S. and Japan clusters go to "180" but the Japanese cluster is KPH and the U.S. is MPH

maduhbee

hrm actually i've seen one in MPH on one of the guy's website on here... i think it was spiritrx7.com... they have a shot of the gauge cluster where it actually says "MPH"

quicksilver_rx7

If you saw it, it's either photoshopped or someone re-cailbrated it and put an MPH sticker on it.

andrewrx7

If the pic you saw was on spiritrx7.com (my site), then the gauge has been modified to read mph. Since the cars were only sold in Japan, they only have kph calibration. Its fairly easy to take out the dial face, and stick a label over the kph to read mph. It is a must in the UK, where the speedo face has to have mph on it.

maduhbee

hehe, i can adjust to the KPH.. i just want this guage cluster!!!